Husqvarna 550iBTX Workshop Manual page 15

5.9.2.3 To remove and install the cruise control button
1. Disassemble the operation handle. Refer to
replace the main cable in the operation handle on
page 13 .
2. Remove the screw and remove the cruise control
button.
3. Pull out the connector of the cruise control button.
4. Assemble in opposite sequence.
5.9.2.4 To replace the main cable in the motor housing
WARNING: Disconnect the battery to prevent
short circuit.
CAUTION: Do not pull the wires.
1. Remove the support. Refer to
the support on page 12 .
2. Disassemble the motor housing. Refer to
disassemble and assemble the motor housing on
page 12 .
3. Remove the 2 screws and lift the plate.
761 - 002 - 18.11.2019
To
To remove and install
To
4. Remove the strain relief (A).
A
B
5. Disconnect the connector (B).
6. Remove the EMC filter (C) from the main cable.
7. Install the main cable in opposite sequence.
5.9.3 To replace the motor
1. Disassemble the motor housing. Refer to
disassemble and assemble the motor housing on
page 12 .
2. Remove the motor cables.
3. Remove the motor.
4. Install in opposite sequence.
C
To
Repair instructions - 15