Honda HRX537HYE Owner's Manual page 8

If the grass catcher needs replacement, you can remove and install a
catcher yourself (page 17).
Installation
1. Raise the
cutting-means
[3]
enclosure [1], and
use the grass
catcher handle [3]
to hook the grass
catcher [2] onto the
mower deck as
shown.
2. Release the
cutting-means
enclosure to secure
the grass catcher.
Removal
1. Raise the
cutting-means
enclosure, grasp
the grass catcher
handle, and
remove the grass
catcher.
2. Release the
cutting-means
enclosure.
3. When the grass
catcher is clear of the cutting-means enclosure, you can lift it
through the handlebar opening, or you can remove it to the rear of
the mower below the handlebar.
Cutting Height
Check the mower deck cutting
height settings, and be sure
that all four adjustment levers
[1] are set to the same cutting
height position.
To adjust cutting height, pull
each adjustment lever [1]
toward the wheel, and move it
into another notch.
If you are not sure what cutting height to select, start with a high
setting and check the appearance of the lawn after mowing a small
area. Then readjust cutting height if necessary.
[1]
8
[1]
[2]
[1]
19 mm
32 mm
45 mm
62 mm
75 mm
88 mm
101 mm
Rear Shield
During normal use the rear shield [1] is subject to deterioration and
wear. Remove the grass catcher [2] and raise the cutting-means
enclosure [3] to check the rear shield for cracks or tears. If the rear
shield is excessively worn, have it replaced by your authorized Honda
servicing dealer.
[3]
Clip Director
Clip Director Knob Adjustment
Adjust the Clip Director knob [1] in any one of the ten positions to
achieve the desired mowing results.
To adjust the Clip Director knob, pull the knob downward and towards
the rear of the mower. The knob adjusts a sliding door [2] from the
fully open BAG position to the fully closed MULCH position (see the
following page).
[1]
If a high resistance is noticed when moving the Clip Director knob
from side-to-side, excessive grass may have built up on top of the
sliding door.
Some grass accumulation in the discharge chute is normal when the
Clip Director is fully closed. To remove this grass, close the
cutting-means enclosure, fully open the Clip Director, start the engine,
and engage the cutting-means control lever several times.
Important Safety Precaution
Always turn the engine off and disconnect the spark plug cap before
lifting the cutting-means enclosure to view or clean around the sliding
door. This will prevent contact with the rotating cutting means and
prevent objects from being thrown into the discharge area.
ENGLISH
[2]
[1]
[2] (fully closed)