Changing jumper settings
Caution
Do not alter any jumpers or switch settings other than those identified
here, unless told to by your supplier or an authorised maintainer.
Otherwise, you may damage the system processor, the motherboard, or
both.
There are only a few jumpers on the motherboard that you may
need to alter. All others are set at the factory and should not be
changed.
In this section, "1-2" means the jumper should be fitted across pins
1 and 2, "2-3" means the jumper should be fitted across pins 2 and
3, and so on. "Open" means that no jumper should be fitted;
"Closed" means that all jumpers should be fitted.
On the motherboard, pin 1 of each jumper block is indicated by a
small triangular marking.
PL32
PL37
PL36
APRICOT LS/VS340 OWNER'S HANDBOOK
I n s i d e t h e S y s t e m U n i t
PL2
PL100
PL22
PL11
PL10
PL8
PL3, PL4, PL6,
& PL7
A/5