Table of Contents
Advertisement
CAUTIONS
1. Correct this document from the errata before doing anything
else.
2. Do NOT insert or remove the MDS controller from the computer
while the power is turned on.
3. Do NOT insert or remove IC's from the board while the power is
turned on.
4. Be sure the +5 volt regulator is generating +5 volt output
voltage before installing any IC·s.
5. Be careful to insert all IC's in correct positions and with
correct orientation.
6. Do NOT connect or disconnect, mount or dismount, or in any way
physically tamper with the disk drive, power board, or disk
controller while the power is turned on.
7. In some cases disk drives may not operate properly if located
in the vacinity of TV's, electric motors, or other sources of
electrical noise.
This may be remedied by moving the disk
drive away from the noise source or by installing the disk
drive in a grounded cabinet.
North Star MICRO-DISK System
2
Advertisement
Table of Contents
