Certification And Standards; Table 2: General Description B) - Siemens MC35 Migration Manual

Migration from MC35 to MC35i
P R E L I M I N A R Y

Table 2: General description b)

Features
Data Supported services
USSD support
Connection element
Autobauding
Fax Supported classes
GPRS Connectivity
Data downlink transfer
Data uplink transfer
Coding scheme
PAP (Password
Authentication Protocol)
Challenge Handshake
Authentication Protocol
Packet Switched Broadcast
Control Channel (PBCCH)
External interfaces RF interface:
Power:
Application interface:
Serial interface Baud rate:
Local character framing:
Multiplex mode:
Flow control:
Software update
3.2

Certification and standards

Both MC35 and MC35i comply with the same directives and standards. However,
please note that a new R&TTE approval of the host application is required after
migration from MC35 to MC35i.
For further information please consult the HW manual for M35 and MC35i.
Migration from MC35 to MC35i
Parameter
Fixed range
(300bps...115kbps)
Autobauding
(1.2kbps...115kbps)
RTS/CTS hardware handshake and software XON/XOFF flow control.
Via serial interface and SIM interface
8 of 30
MC35
2400 bps (V.22bis)
4800 bps (V.32)
9600 bps (V.32)
14400 bps (V.34)
2400 bps (V.110)
4800 bps (V.110)
9600 bps (V.110)
14400 bps (V.110)
Supported
non-transparent mode
supported
Group 3: Class 1, Class 2
GPRS multi-slot class 8
GPRS mobile station class B
max. 85.6 kbps
max. 21.4 kbps
CS-1, CS-2, CS-3 and CS-4
Supported
Supported
Supported
GSC antenna connector only
3 additional power pads available
40-pin ZIF connector
Fixed range (300bps...230kbps)
Autobauding (1.2kbps...230kbps)
8N1- fixed
Supported
MC35i
12.03.03