Table of Contents
Advertisement
Saving parameter changes
Note
When you make changes to a parameter with the BOP, they are maintained only in the RAM
memory so that if the power is cycled prior to performing a Save Function, your changes will be
lost. To avoid this, save the data set either to the ROM-Non Volatile Memory, or both the
ROM and Micro Memory Card. Both options are described below.
RAM to ROM
At any point during the commissioning, the data can be saved to non-volatile memory. This is
initiated by pressing and holding the
indicating the RAM to ROM function is active.
When complete, the display will stop flashing and remain solid.
RAM to ROM
1. Set S120 display to drive number 01 (see Switching units (Page 16)).
2. With the Power ON, insert the Micro Memory Card into the card slot below the BOP Display
and ensure the card locks into place.
3. Use
4. Press
initiates a function within the Control Unit.
5. Use
The display will begin to flash indicating that the save function is active. The Data Set
currently active in the RAM will be saved to the ROM (Non-Volatile Memory) as well as the
MMC card.
Note
This type of saving will overwrite any existing Data Set with the index of 0 on the Micro
Memory Card. You should only have a Data Set with an index of 0.
4.2.1.5
Additional notes and important information
Inputs and outputs
All inputs and outputs are identified on the schematics act as discreet I/O to the CU305DP
Control Module. All related functions for the I/O are programmed internally to the Control Unit,
therefore, requiring specific States and or Change in States for proper drive functionality.
Please review the electrical schematics to understand what inputs are required for Hand or
Automatic mode enable signals as well as the Analog Speed reference signals.
Each of the labeled inputs has been programmed into an AND/OR gate function, and therefore
is required for operation of the drive. A brief description below will help explain the input
requirements:
SITRANS WW100
Operating Instructions, 06/2018, A5E33560618-AC
and Micro Memory Card, P977=1.
or
arrows to navigate to P0977.
so the current parameter value is displayed. The default value is 0. Any other value
or
arrows to set the value to 1.
4.2 Electrical installation for servo driven models
key for three seconds. The display will begin to flash,
Installing
19
Advertisement
Table of Contents
