ResMed AirMini User Manual page 15

Remove the HumidX/HumidX Plus (N20 and AirFit P10 for AirMini
masks only)
Disconnect the mask tube from the
vent module by gently twisting and
pulling the two pieces apart. If you
are using the HumidX or HumidX
Plus, remove it from the vent
module.
Note: The HumidX and HumidX
Plus cannot be washed as this will
affect the performance of therapy.
Unplug the machine
1. Disconnect the AirMini tubing
from the machine by pressing
the side buttons on the cuff and
pulling it away.
2. Unplug the power supply unit
from the power outlet and the
machine.
For mask disassembly instructions, refer to your mask user guide.
Cleaning and replacing parts
Detach all components according to the disassembly instructions and
make sure that the HumidX/HumidX Plus is removed and stored in a
clean, dry location.
Inspect the HumidX/HumidX Plus
1. Check daily for any signs of damage or blockages caused by dirt or
dust.
2. It must be replaced within 30 days after opening.
3. When the HumidX/HumidX Plus is not being used, store it in a clean,
dry location.
Note: HumidX/HumidX Plus cannot be washed.
English 13