Removing - Epson EB-L1075U User Manual

Installing the Projector
Attention
If the message "Lens Calibration failed." is displayed, remove the lens unit and
then reinstall it. If the message continues to be displayed, stop using the
projector, remove the power plug from the electrical outlet, and contact your
local dealer or the nearest address provided in the Epson Projector Contact
List.
Epson Projector Contact List
s
a
• You can perform lens calibration using one of the following
methods.
- Press the [Default] button on the remote control for three seconds
or more.
- Configuration Menu
s Extended - Operation - Lens Calibration
• If no message is displayed after attaching the lens unit, perform lens
calibration from the Configuration menu.
• If you do not calibrate the lens, the following functions may not
operate correctly.
Focus, Distortion, Zoom, Lens Shift, Memory (Lens Position)

Removing

Caution
Wait for a while after turning off the projector before removing the lens unit
(Approx. 30 mins.). Touching the lens unit immediately after projecting or
turning off may cause burns.
Attention
If the lens shift has been done, move the lens position to the home position
before replacing the lens unit.
s "Adjusting the Position of the Projected Image (Lens Shift Adjustment)"
p.34
a
a
Pull the lens replacement cover straight out.
p.146
b
If the lock lever has been secured with a stopper, remove the
stopper.
The projector uses a laser as the light source. As a safety measure, the
light source turns off when the lens is removed. Attach the lens, and
then press the [ ] button to turn it back on.
30