Table of Contents
Advertisement
Enabling ARP/Ping to set IP Address Service
If you know the camera's MAC address, then use the ARP/Ping command to modify or set the
camera's IP address.
Before operating the camera, please ensure that the network camera and the PC are in the same
LAN. This function is On by default. To enable ARP/Ping to set the IP address service:
1.
2.
3.
4.
5.
6.
P2P
P2P is an easy connection method that can make it simple to connect to your network devices
with your mobile device with the HonView Touch App. First you will need to download the
HonView Touch app and then register/create an account. When the app is setup, select to add
a device and use the mobile device's camera to view the QR Code on the P2P screen of your
camera's web client (see
automatically be downloaded to the HonView Touch app and you can now connect to the
network camera using your mobile device.
Table 5-13
TCI/IP Configuration (cont'd)
Parameter
Function
If Static mode is selected, type values for the IP Address, Subnet
IP Address
mask, and Default Gateway.
Preferred DNS
Enter the preferred DNS server IP address.
Server
Alternate DNS
Enter an alternate DNS server IP address.
Server
Get an IP address. Set up the network camera and the PC in the same LAN.
Get the physical address (MAC) from the label on the network camera.
Open the Run interface (Start menu
arp -s <IP Address> <MAC>
a.
ping -l 480 -t <IP Address>
b.
For example:
arp -s 192.168.0.125 11-40-8c-18-10-11
a.
ping -l 480 -t 192.168.0.125
b.
Reboot the camera. If the setup was successful, output information such as Reply from
192.168.0.125... will appear in the command output lines.
Close the command line.
Open your browser, type http://<IP address> in the address bar, and then press Enter.
Figure
Run), and then type the following commands:
5-16). The device's information and connection will
Configuring Camera Settings | 53
800-22757 - A - 02/2017
Hide quick links:
Advertisement
Table of Contents
