Download Print this page

Watchguard XCS 1180 Manual page 6

Rack mount kit

Hide thumbs Also See for XCS 1180:

Remove the XCS 1180 Device from the Rack

The XCS 1180 rack mount system includes two sets of rail stops. You must press the tabs on the inner rail pieces

to slide past the rail stops and remove the device from the rack. The tabs are located on each inner rail piece.

Each tab looks like this:

To remove the XCS 1180 from the rack:

1. If the XCS 1180 is secured to the front of the rack with rack screws in the ear brackets, make sure you

remove the rack screws.

2. Slide the device out about half way until the first rail stops catch on each side.

3. Press the tabs on the inner rail pieces on both sides while you pull the device farther out.

4. Continue to slide the device out until the second rail stops catch on each side.

5. Press the tab on the inner rail pieces on both sides while you pull the device farther out.

6. Slide the device out of the rack.

CAUTION:

We recommend that at least two people be present to remove the device from the rack.

WatchGuard, the WatchGuard logo, LiveSecurity, and any other mark listed as a trademark in the "Terms of Use" portion of the

WatchGuard Web site that is used herein are either registered trademarks or trademarks of WatchGuard Technologies, Inc. and/or its

subsidiaries in the United States and/or other countries. All other trademarks are the property of their respective owners.

Revision date: April 12, 2013

Part Number: 369-4554-001 Rev A

WatchGuard XCS 1180 — Rack Mount Kit