Page 1
XCS 1180 Rack Mount Kit This guide describes how to use the rack mount system to install your XCS 1180 Series device in a network rack. Rack Mount Kit Contents ® Each WatchGuard XCS 1180 device ships with a rack mount system.
Page 2
When you mount the device in the rack, avoid hazardous conditions caused by uneven mechanical loading. Circuit Overloading Make sure you connect the XCS 1180 device to the power supply circuit in such a way that there is no overloading of the circuits, and no impact on overcurrent protection and supply wiring. Reliable Grounding Make sure all rack-mounted equipment is correctly grounded.
Page 3
Use these steps to attach the inner rail pieces and front mounting brackets to the XCS 1180 device. 1. Position two inner rails along one side of the XCS 1180 chassis. Make sure that the finger tabs are facing out and are positioned towards the rear of the unit.
Page 5
Install the XCS 1180 Device in the Rack Use these steps to complete installation of the XCS 1180 device in the rack. 1. Hold the XCS device with its front facing you. 2. Lift the XCS device and carefully slide the inner rail pieces on each side of the chassis into the outer rail on each side of the rack.
Page 6
Each tab looks like this: To remove the XCS 1180 from the rack: 1. If the XCS 1180 is secured to the front of the rack with rack screws in the ear brackets, make sure you remove the rack screws.