Adding Channels To The Tv's Memory; Programming Channels Automatically - Toshiba 27A60 Owner's Manual

To select the antenna input:
1. Press the TV/VIDEO button on the TV. The signal source you
are connected to is displayed in purple.
2. Press the button until ANT 1 or ANT 2 is displayed in purple,
indicating the antenna terminal you wish to use.

Adding channels to the TV's memory

Your TV will stop on specific channels that are stored in the TV's
channel memory when you press Channel
to set all active channels in your area automatically.

Programming channels automatically

Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory, you
can erase channels or add your favorite channels. If you use both
ANT-1 and ANT-2 terminals, you must program channels for each
input source.
To add channels:
1. Press MENU, then press
2. Press or until the TV/CABLE selection is highlighted.
y z
3. Press or to highlight either TV or CABLE, depending on
x •
which you use.
If you use an antenna, choose TV.
If you use cable, choose CABLE.
4. Press to select CH PROGRAM.
z
5. Press or to start channel programming. The TV will automati-
x •
cally cycle through all the TV or Cable channels (depending on
which you selected), and store all active channels in the
channel memory.
While the TV is cycling through the channels, the message "CH
PROGRAM" appears.
6. When channel programming is complete, the message "CH
Completed (channel or cable number)" appears.
7. Press Channel L or M to view the programmed channels.
L or M . Use the steps below
or to highlight the SET UP menu.
x •
13
TV/VIDEO
POWER
MENU
TV/VIDEO VOLUME CHANNEL
T S t s
POWER
RECALL MUTE
2
1 3
4 5 6
7 8 9
CH RTN
100 ENT
0
CH
Menu/Enter
MENU/
VOL VOL
ENTER
CH
TV
CABLE
Exit
VCR
EXIT