Stanley DL07 User Manual page 3

Gloves can become entangled with the rotation drive, causing severed
or broken fingers.
M003
Wear Ear
Protection Protection
Sound
• Exposure to high noise levels can cause permanent, disabling hearing
loss and other problems, such as tinnitus (ringing, buzzing, whistling
or humming in the ears). Use hearing protection in accordance with
employer's instructions and as required by occupational health and
safety regulations. Appropriate controls to reduce the risk can include
actions such as damping materials to prevent work pieces from
"ringing".
• Use and maintain as recommended in the manual to prevent an
unnecessary increase in noise levels.
Vibration
• When using a rotary tool to perform work related activities, the
operator can experience discomfort in the hands, arms, shoulders, neck
or other parts of the body.
• If you experience numbness, tingling, pain or whitening of the skin
in your fingers or hands, stop using the tool. Tell your employer and
Tool Anatomy
Planetary Gearbox
Chuck
Trigger
Trigger Guard
M004
M016
Wear Eye
Wear a Mask
consult a physician.
• Wear warm clothing when working in cold conditions and keep your
hands warm and dry.
• Exposure to vibration can cause disabling damage to the nerves and
blood supply of the hands and arms.
• Do not touch sockets or accessories during impacting. This increases the
risk of cuts, burns or vibration injuries.
• Use and maintain as recommended in the manual to prevent an
unnecessary increase in vibration.
• Check the vibration level after each service. If higher than normal,
contact your STANLEY dealer.
Hydraulic
• Warning: Hydraulic fluid under pressure could cause skin injection
injury. If you are injured by hydraulic fluid, get medical attention
immediately.
• Do not let hydraulic oil get on the skin. Hydraulic oil is hot. Wear
Personal Protection Equipment (PPE) at all times.
• Do not exceed the maximum relief valve setting stated on the tool.
• Inspect and clean couplers before use, daily. Replace damaged couplers
immediately.
• Hydraulic circuit control valve must be OFF before coupling or
uncoupling tools. Failure to do so may damage the couplers and cause
overheating of the hydraulic system.
• Ensure the couplers are properly connected and are tight.
• Do not operate the tool at fluid temperatures above 140°F (60°C).
Higher temperatures can cause operator discomfort and damage to the
tool.
• Do not exceed the rated flow and pressure as stated on the tool. Rapid
failure of the internal seals may result.
Rotation Direction Valve
Hydraulic Motor
Hydraulic Circuit &
Tool Activation Valve
Chuck
Secures the bit during tool operation.
Planetary Gearbox
Provides torque and rotational speed to the chuck
from the hydraulic motor.
Rotation Direction Valve
Used to select bit rotation direction.
Hydraulic Motor
Translates flow and pressure from the hydraulic
power source into rotational motion. Tool RPM
can be adjusted by changing flow/pressure of the
hydraulic power source. See "Torque and Drill
Speeds @ Flow" on page 8.
Hydraulic Circuit & Tool Activation Valve
Selects the hydraulic circuit being used (open center
/ closed center). Also activates the tool when the
trigger is pressed.
Trigger
Activates the tool.
Trigger Guard
Guards the trigger from accidental activation.
DL07 User Manual | 3