Table of Contents
Advertisement
BXR836 RIDE-ON TROWEL INSTRUCTION MANUAL
4. BELT CHANGE PROCEDURE
Remove belt cover from the machine to expose the
drive components. To change the primary drive belt,
remove clutch from engine drive shaft, by removing
bolt from the clutch. This releases belt from both the
clutch and driven unit.
5. BELT TENSIONING SPECIFICATIONS
NOTE:
Belts may become slightly loose after the first
few hours of operation. It is important to re-
tension the belts with the tool provided and use
the table given as reference.
LUBRICATION
1. ENGINE OIL
The long life and successful operation of any piece
of machinery is dependent on frequent and thorough
lubrication.
Before using the trowel, always check your engine
for oil. Use proper engine oil as recommended in the
engine manufacturer's manual. Fill crankcase to
levels as recommended.
2. SPIDER PLATE
There are 8 (eight) grease fittings on the spider
plates, 4 (four) on each must be greased daily.
SPIDER PLATES MUST BE GREASED EVERY
TIME MACHINE IS USED.
375 ANNAGEM BLVD. – MISSISSAUGA – ONTARIO – CANADA – L5T 3A7 – 866-501-1683 – FAX 905-364-4200
375 ANNAGEM BLVD., MISSISSAUGA, ONTARIO, CANADA, L5T 3A7, 905-364-4200 FAX 905-364-4201
25 INDUSTRIAL DR. – KEYPORT – NEW JERSEY – USA – 07735 – 888-999-1570 – FAX 732-566-5444
200 COMMERCE DRIVE, FREEHOLD, NEW JERSEY, USA, 07728, 732-566-6400 FAX 732-566-5444
BARTELL MORRISON INC.
3. GEARBOX
Check the oil level sight plugs on both gearboxes
daily to ensure the oil is half way on the site glass.
Top up with Agma 8 compounded gear oil only.
Gearbox capacity on the BXR836 is 27oz./767ml.
4. TO CHANGE GEARBOX OIL
Place a pan beneath the drain plug to catch the oil.
Remove the drain plug and the filler plug from the
gearbox. After the oil has drained completely, replace
the drain plug and tighten. Fill the gearbox through
the filler plug with 27oz./767ml. of Agma 8
compounded gear oil. Replace the filler plug and
tighten.
5. GREASE FITTINGS
There are 6 bearings in total. Grease all bearings and
U-joints to ensure adequate supply of lubricant. They
are located above the gearboxes (2 per gearbox) and
2 located in the drive system. The U-joints are
located in the drive system as well.
BARTELL MORRISON (USA) LLC
11
11
Created: 05/2012
Revised: 00
CREATED: 07/04
Revised: 05/2012
REVISED: 06/14
Advertisement
Table of Contents
