6.2 PRE-OPERATION CHECKLIST
Efficient and safe operation of the Meridian Bulk
Seed Tender system requires that each operator
reads and follows the operating procedures and all
related safety precautions outlined in this section.
A pre-operational checklist is provided for the
operator. It is important for both personal safety
and maintaining the efficient operation of the
delivery system that this checklist be followed.
Before operating the delivery system and each
time thereafter, the following areas should be
checked:
1. Lubricate the machine, as outlined and shown
in the Grease/Lubrication Location Diagram
in the Maintenance section of this manual.
Follow the prescribed schedule.
2. Check the engine fluid levels, fuel, and
crankcase oil. Add as required.
IMPORTANT
The engine warranty is void if the engine is run
without oil.
3. Check hardware and fasteners; seed tender
frame to trailer tie-downs, hitch bolts, trailer
hitch to trailer bolts, and all other fasteners.
Tighten to their specified torque.
4. Make sure the wheel bolt lug nuts are tight.
5. Check the tires and ensure that they are
inflated to their specified pressure.
6. Remove all entangled material.
7. Visually inspect the conveyor and frame for
damage.
8. Test the Break-Away brake unit and the trailer
brakes.
• Make sure the trailer brakes are operating
properly.
• Make sure the trip wire to the break-away
switch is connected to the tow vehicle.
• Make sure the pin is correctly installed in
the break-away switch.
• Press the Test button. The indicator should
illuminate green. If the red light illuminates,
the battery charge is low. Refer to the
Break-Away System in the Maintenance
section for instructions on charging the
battery.
32
9. Check the fluid level in the hydraulic tank. Add
fluid as needed.
10. Start the engine and check the filter status
indicator. Replace the filter if indicated.
11. Check the tension of the delivery belt. Follow
the instructions in the manual to correct the
tension and/or alignment.
12. When the machine is operating, check the
alignment of the delivery belt. Follow the
instructions in the manual to correct the
tension and/or alignment.