ECS 945PL-A Manual page 38

32
IDE Configuration (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
CMOS Setup Utility - Copyright (c) 1985-2004, American Megatrends, Inc.
IDE Configuration
ATA/IDE Configuration
Legacy IDE Channels
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave
Hard Disk Write Protect
IDE Detect Time Out (Sec)
ATA (PI) 80Pin Cable Detect [Host]
F7:Previous Values
ATA/IDE Configuration (Compatible)
The ATA/IDE option can be configured as "Disabled", "Compatible (default)" and "Enhanced" in the
BIOS configuration. Windows* 98SE and Windows* Me operating systems do not support Enhanced
mode IDE/Serial ATA resources for more than four devices. If the ATA/IDE option is set to Enhanced
mode, the operating installation will not be able to recognize the drive, and the installation will fail.
Before installing 98SE or Me, the ATA/IDE configuration must be changed from Enhanced to Legacy
mode.
IDE Chennels (SATA Pri, PATA Sec)
Use this item to set up the primary and secondary sequence of IDE channels and SATA channel. If
set ATA/IDE Configuration to Compatible mode and IDE channels to SATA Pri/PATA Sec, users can
only plug in SATA devices on SATA1 and SATA2; if set ATA/IDE Configuration to Compatible mode and
IDE channels as SATA Sec/PATA Pri, users can only plug in SATA devices on SATA3 and SATA4 or else
SATA devices will not be recognized. If set ATA/IDE Configuration to Enhanced mode, then SATA
devices can be plugged into any SATA connector.
Primary/Secondary IDE Master/Slave(Not detected/ATAPI CDROM)
Your computer has two IDE channels and each channel can be installed with one or two devices
(Master and Slave). In addition, this motherboard supports four SATA channels and each channel
allows one SATA device to be installed. Use these items to configure each device on the IDE channel.
If any IDE device is detected in any one of the above items, press <Enter> to reveal the following
information.
IDE Configuration
[Compatible]
[SATA Pri, PATA Sec]
[Not Detected]
[Not Detected]
[Not Detected]
[ATAPI CDROM]
[Disabled]
[35]
+/-/:
: Move Enter : Select Value
F10: Save
F8:Fail-Safe Defaults
Using BIOS
Help Item
Options
Disabled
Compatible
Enhanced
F1: General Help
ESC: Exit
F9: Optimized Defaults