Table of Contents
Advertisement
MANAGE PRESET
This function is used to manage presets with the following buttons:
- Select All = to select all the Presets of all Programs.
- Show Selected = to select only the relevant Presets.
- Show Program = to select the Presets inside the various programs.
Presets can be removed from the program, after being selected,
by pressing the trash can icon (unlink/delete) and then the RE-
MOVE button to unlink them from programs or DELETE to remove
them completely.
4.8 CLEANING
CLEANING SYSTEM
This cleaning system carries out automatic compartment washing
with suitable detergents according to the amount of grime detected;
therefore the following 4 cycles have been provided for:
CLEAN Soft
For still fresh grime from not very greasy cooking (e.g.
with STEAM cycle)
CLEAN Medium
For normal grime from greasy cooking.
CLEAN Strong
For heavy grime from very greasy cooking (e.g. roast
chicken, sausages).
CLEAN Extra Strong
For heavy grime from very greasy cooking (e.g. roast chi-
cken, sausages) even with dried residuals (encrustations).
To use these stored programs, proceed as follows:
Note 1:
Before cleaning the compartment with the CLEANING SYSTEM,
remove the grease fi lter (if present).
The CLEANING SYSTEM cycle starts when the temperature
has automatically reached 158°F (70°C) in the compartment.
Before carrying out a CLEANING SYSTEM cycle, make sure there
is detergent in the containers (located under the control panel on
models 6-10GN1/1-2/1 or independent in models 20GN1/1-2/1)
and that it is of the required type, therefore see par. 6. CLEANING
AND MAINTENANCE.
Warning:
(
)
In case of complete emptying of the detergent and/or rinse aid
containers or emptying of their supply tubes, the CLEANING
SYSTEM cycle must be started after fi rstly doing the CLEAN 1
cycle, then the same or other cycles. This operation allows the
pipes to be refi lled with the appropriate liquids and the cleaning
cycles to be done correctly.
If the CLEANING SYSTEM is not used for long periods, it is
necessary to do a cleaning cycle (CLEAN 1) with water instead
of detergent and rinse aid before and afterwards, to fl ush the
respective supply pumps.
• Select a cleaning cycle (Medium is preset).
• If necessary, select one of the Green Spirit / Economizer
functions.
If "Skip Rinse Aid" is selected, remember that the traces of
scaling could remain in the compartment after cleaning.
For "Skip Drying Phase" it is necessary to open the door
after cleaning, to air the oven.
For "Reduce Water Consumption" make sure an effi cient
ventilation system is installed.
Reduction occurs by deactivation of fume suppression.
• Press START to start the cycle.
If necessary, to stop the cleaning cycle press STOP for a few
seconds.
Note 2:
The setting of the "Green Spirit / Economizer" functions is only
TEMPORARY on this screen; for a PERMANENT setting, select
the same functions in par. "4.8 SETTINGS" under GREEN SPIRIT
/ Cleaning.
35
Cleaning
Green Spirit
Soft
0:45
Medium
1:00
Strong
1:30
Extra Strong
2:30
Green Spirit
Skip Rinse Aid
Soft
0:25
Skip Drying Phase
Reduce Water Consumption
Medium
0:55
The "Green Spirit / Economizer" function
/
enables use of the cleaning programs in respect
for the environment.
USA
Green Spirit /
Economizer
or
and
0:35
0:25
0:45
0:35
1:15
1:05
2:10
2:00
Cycle duration
2 hours
30 minutes
/
Advertisement
Table of Contents
