Topfield TF6400IR User Manual page 33

When you switch to an service, if the service is
provided by a satellite other than current one,
it will take longer time than usual because the
antenna has to turn to its position.
To get the correct position of your desired satellite, perform the
following steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Set the DiSEqC Command Mode option to User.
3. Set the Motor Control option to Goto. Then the antenna
will turn toward your selected satellite by the position
data that the digital receiver has.
4. If the receiving quality, which is displayed at the bottom
right of the screen, is not good, tune the antenna finely
with the Movement option. If you set it to 2(E), the an-
tenna will move to the east by two degrees. At this time
you had better check the receiving quality of every trans-
ponder and choose the best one at the Transponder (or
Frequency) option. It will be helpful to your fine tuning.
4.1 Searching broadcasting services 27
To use the DiSEqC 1.2 protocol,
select the Installation
ized DiSEqC 1.2 menu.
should see a screen like the left
figure.
At first you have to set the Mo-
torized DiSEqC 1.2 option to En-
able.
Motor-
You