Step 14, Install Grille Base Wrap - GE ZICP720 Design Manual With Installation Instructions

14 INSTALL GRILLE BASE WRAP
• Open doors fully. Open the grille panel.
• Install the unified double width grille base wrap (E)
by slipping the notched ends over the door hinges.
• Install one screw (I) on each end and 2 at the center.
Unified Grille Base Wrap
15 CONNECT WATER SUPPLY
Connect both refrigerators to the water supply.
• Locate and bring tubing to the front of the cabinet.
• Turn the water on to flush debris from line. Run
about a quart of water through tubing into a
bucket, then shut off water.
Copper Tubing:
• Slip a 1/4" nut and ferrule (provided) over both
ends of the copper tubing. Insert tube into the
union fitting on the unit and tighten nut to union.
• Turn on the water to check for leaks.
Installation Instructions
17
House
Water Supply
GE SmartConnect Tubing:
™
• Insert the molded end of the tubing into the
refrigerator connection. Tighten the compression
nut until it is just hand tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not
interfere with drawer closing or toekick installation.
Place Trim
Over Hinges
Refrigerator
Water Supply