Barring Outgoing Calls; Default Settings (Reset)Of The Parameters - Topcom Cocoon 350 User Manual

Cocoon 350

4.28 Barring outgoing calls

You can program the handsets to bar calls to certain telephone numbers so that for instance '00'
international numbers cannot be called. Up to 5 numbers (of max. 5 digits) can be barred.
To do this, do the following:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'PIN' appears on the display.
• Enter your PIN code
• Press the Programming key
• 'BAR NUM ' appears on the display. You are in memory "1. _ _ _ _ _".
• Press the Up or Down key
• Enter the number (max. 5 digits) to be barred, e.g. 01486.
• Press the Programming key
• 'HS _ _ _ _ _' (= number on the handset (1-5)) '01486' (= the barred numbers) appear on
the display.
• Enter the numbers of the handsets from which the barred numbers cannot be called.
• e.g. Press the number key 2, 3 and 5. On the display, this will appear: HS _2 3_5 01486
These handsets can no longer dial numbers beginning with '01486'.
• Press the Programming key
Repeat the same procedure described above if you would like to bar other numbers (max. 5)!
4.29 Default settings (reset) of the parameters
You can reset the standard (default) settings in the telephone so that they are the same they
were when you bought the telephone. You need the PIN code to do this.
The default settings are:
- Keypad:
- Key clicks:
- Speaker volume:
- Ringer melody:
- Ringer volume :
- Selection base unit:
To restore the default settings, do the following:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'PIN' appears on the display.
• Enter your PIN code.
• Press the Programming key
.
repeatedly until 'SETTING' appears on the display.
.
repeatedly until 'BARRING' appears on the display.
.
.
to select one of the 5 memories.
.
to confirm your selection.
Answering machine:
not locked - Answering machine:
active - Standard message:
level 3 - Number of rings:
1 - Remote control code:
5
automatic
.
repeatedly until 'SETTING' appears on the display.
.
repeatedly until 'RESET' appears on the display.
.
.
23 23 23 23 23 23 23 23 23 23 23
on
OGM1
3
321