Page 1
Maximum operational power for PCI: 3 W (0.6 A @ 5 V) For PCI Express: 2.5 W (0.76 A @ 3.3 V) PCI-Express details 1 Lane PCI Express bus Compatible with 4x, 8x and 16x slots Faceplate Sangoma Telephony cards ship pre-installed with 1 U faceplate, along with a 2 U faceplate as accessory.
Page 2
B700 BRI Termination resistors to switch between NT and TE modes The B700 comes with termination resistors that have to be disabled (set to OFF) when running in TE mode and enabled (set to ON) when running in NT mode.
Page 3
FXO/FXS Module Installation Slide the module into the main card until they click in properly. You should be able to read the designation on the outside of the card (Remora) after installation. FXO modules are in color FXS modules are GREEN in color FXO/FXS Modules have...
Page 4
How to Connection PSTN lines to A500: Telephony card installation is very simple: Power off server and remove cover to access the PCI/PCIexpress slots Identify the PCI/PCIexpress slot to be used for your telephony card Remove the backplate for that slot, from the server. This backplate may require screwdriver to remove screws before pulling off the backplate.
Software Installation Select your Installation type: Install with FreePBX Distro Install with your own Asterisk server Install with FreeSWITCH Install with API...