Restart Of Infopoint; Updating Firmware; Change Settings - Siemens SiPass Entro Configuration Manual

4.2

Restart of InfoPoint

4.3

Updating firmware

4.4

Change settings

Building Technologies
Fire Safety & Security Products
If you need to restart the InfoPoint you do this by simultaneously pressing the three
keys shown in the figure (compare to Ctrl Alt Del in a PC).
Note that no parameters are changed – only a restart takes place in the same way
as you connect the power.
If the Entro system offers a new firmware version for the InfoPoint you can
download this (from the SR35i) with a special command. The file is stored on the
CF8 card and the InfoPoint will check if it is a recent version. (If it is older it will not
be downloaded).
Remember that all address settings (such as IP, Server IP, Netmask etc) must be
correct in order for the download to take place. If Reservation has been working
before, the settings should of course be correct.
You start the download by restarting (see above) and then press and hold down
the key furthest to the right.
A message will be shown when downloading starts.
If any parameters need to be changed (e g the IP-address) – proceed as follows:
1. Disconnect the power supply – or reboot and hold the marked button (see fig-
ure) to the right until you hear three beeps.
2. Actual settings are displayed on the screen. There are two pages with settings
and you will see the next one by pressing "Next Page".
3. Edit necessary changes accordingly.
4. Save by pressing the function button Save and Exit (or abort by pressing
Cancel).
Set-up
13
06.2009