Roland V-Synth XT Service Notes page 30

MAY.2005
fig.gidstamp.eps
If the model ID has registered, select the "V-Synth XT" in the item of [Select
Model] field.
Please advance to procedure 7.
fig.gidstampxt.eps
3.
When [Model Info.] is clicked, the Model input dialog is displayed.
fig.gmodel.eps
4.
Then [Add New Model] is clicked, the Edit input dialog is displayed.
fig.gedit.eps
Input the following items into the appropriate fields.
Model Name
MIDI IN
MIDI OUT
Test Mode Enter SysEx
5.
It returns to the Model input dialog after the Edit input dialog has closed
by pressing "OK"
after the above-mentioned input items have been completed.
6.
Close the Model input dialog to press "OK" The model ID on V-Synth XT
was registered above.
7.
Press the [START] button on the ID Stamp dialog screen.
34
V-Synth XT
Roland V-SYNTH XT
Roland V-SYNTH XT
f0 41 10 00 49 12 4b 03 16 1c f7
fig.gidstamps.eps
Input the serial ID of the product (seven characters) to [SERIAL No] field of
[Input ID] frame,
then press the Enter key of PC.
"Product Data STAMP Complete!" is displayed. Close the dialog by pressing
"OK"
fig.gidstampc.eps
8.
Serial ID is displayed on the screen of V-Synth XT and verify that inputed
Serial ID is correct.
9.
Disconnect the USB cable and verify that the V-Synth XT screen indicates
"DISCONNECT : OK"
10. If "OK" is displayed for all items, the V-Synth XT screen will indicate
"COMPLETE"
fig.PDTestMode16.eps
Writing the serial ID is completed above.