Advertisement
<Set-up»
-ArWhen programming settings, disconnect motor cable's.
Neutral / Maximum acceleration / Maximum reversing (Full
braking)
(J) Securely connect wiring according
to illustration on page 1 (except
motor). Turn on transmitter first,
position throttle trim to neutral and
reverse switch to normal.
~k\f your transmitter is capable of
programmed settings such as ABS
or acceleration function, turn off all
settings.
)Tum on receiver. When installing for
the first time, LED light will flash red
once.
(3) Push set button once with throttle
trigger in neutral.
^Transmitter
throttle trigger
Push set button
(for more than 0.5 sec).
® Pull throttle trigger to maximum ac-
celeration and push set button
once.
LED flashes red.
Maximum
acceleration
© P u s h throttle trigger to maximum
reversing and push set button once.
<3>
LED changes to a
double flash.
Maximum reversing
(Full-braking)
Push once.
<3>
LED turns off.
(§) Setting completed.
(Standard settings)
^Throttle positioning must be set in this sequence and can not be
set individually.
•*-lf power is turned off before completion, the new settings will be
lost and old throttle positioning will remain.
^r/Until you correctly complete the step, you can not progress to the
next one.
lk"You must set new throttle positioning when changing transmitters.
Turning reverse function off
-ArAllows you to enter races forbidding reverse running. Follow the
instructions below to turn reverse function off (pushing throttle trig-
ger will activate brakes only).
^Follow same sequence to turn reverse function on (switches be-
tween on / off setting each time done).
Turn on transmitter. Turn on receiver while holding down the set but-
ton, then release button immediately (within 3 sec.). Flashing LED
quickly flashes red twice and turns off (only flashes once when turn-
ing reverse function on). Setting completed.
# *
#
-
»
-^Checking if reverse function is on or off.
When reverse function is on: LED will flash red once when turning
on transmitter and then receiver.
*
When reverse function is off: LED will flash red twice when turning
on transmitter and then receiver.
Default setting
•ArCancels all changes and returns to original settings at time of pur-
chase.
Turn on transmitter. Turn on receiver while holding down the set but-
ton. Keep holding down button until flashing red light turns green
(app. 3 sea). Release button.
LED light will be green for 2 sec., then turn off. Default setting is
completed.
More than 3 sec.
<S>
Green light (for 2 sec.).
Green
$fc $fe $fc
1) Z. CDtSIiEW** 5 f TEU-302BKIP > y^UWt
-5 =f o ©-CT
0
2)*5H_tB*r*S6$r/3(180B)l3lrtlt:» J E l A ^ t t J S t t f l r ? f t £ U f c
9 51*2) 7*9 V—+J-— fcf 'X Olfisg rT5j§LEBII3-7=f 422-8610> £ £ £ £
0 < KSV^o
fcF^V\-&-t±*!g#-5§-054-283-0003)
S»BfTCDiSe)
J
¥»#AncD^:fflHcd:*ttK!
J
lpa*o ®'A.2H*:<Dibm
izznnmi\-£-?
0
mmsco'mwfyit^tc L.*I±A>C
Effective only in Japan.
Advertisement
