Table of Contents
Advertisement
Front and Rear Panel
13
Rear panel
13. Ventilation fan
14. MIC1 - Microphone number 1 Jack Input [6.3mm (¼")]
15. LINE1 / LINE2 / LINE3 – Analog RCA Inputs (both L/R channels are mixed together)
16. MONO OUT – Analog RCA Output in Mono
17. Additional Speaker Output – 100V, 70V or 8Ω (Screw-in Speaker Connectors)
18. ZONE OUTPUTS -100V Speaker Output (Screw-in Speaker Connectors)
19. Power Cable and Fuse Box
Note! A blown fuse should be only exchanged for exactly the same type as indicated on the
rear amplifier panel. The Power Cable should be disconnected!
Rack installation
This amplifier is designed for installation in a 482mm (19") width rack unit as well as can be used
as a tabletop amplifier.
In the rack the amplifier requires a space of 2 RS (2 rack spaces = 89mm).
•
Hold the amplifier by the handles in position and secure it in the rack with the four mounting
bolts (insert them in the rack mount holes).
•
The mounting bolts alone may be not sufficient for fixing the amplifier safely. We recommend to
use additional lateral rails or a bottom plate to secure the amplifier in the rack.
Note! To prevent the rack from becoming top-heavy insert the amplifier into the lower section
of the rack.
Note! Make sure that the hot air is dissipated from the rack – otherwise you may damage the
amplifier and/or other equipment installed in the rack – this will void your warranty.
14
15
16
17
18
19
7
Advertisement
Table of Contents
