Table of Contents
Advertisement
Operation
1. Plug the Power Cable into the electrical outlet.
2. Switch on the amplifier – press the Power Switch (the Power Switch should be in the
1 position). The ON Power Status LED should turn on in a few seconds. If it does
not, it means that the amplifier is working under an abnormal condition (a protection
mode) – turn off the power, unplug the Power Cable and check whether some of the
cables are not short circuited. After fixing the cables turn the amplifier on.
3. Switch on your audio source and start playback.
ZONE VOLUME Regulators:
Available only for the Zone Output connection option.
For each ZONE you can adjust the sound volume from minimum (the knob – max
counterclockwise) to maximum (the knob – max clockwise).
Note! Distortion and sound quality worsening may occur when the knob is in the
maximum position. It may damage the amplifier or speakers. This may void your
warranty.
Note! High volume levels can damage this amplifier or speakers. This may void your
warranty.
LINE Input Mixing Regulators (LINE1, LINE2 etc.):
Adjust the sound / mixing level input for connected audio source devices: mix and fade-
in / fade-out.
Turn the selected LINE knob clockwise (+) to make the sound of this line more audible
(fade-in) and counterclockwise (-) to make it less audible (fade-out).
Minimum (the knob – max counterclockwise : the marker on the knob shows 0) – no
audio signal is transmitted from this line input.
Additional Speaker Output Connection option - in this option the LINE regulators control
the output level of the Additional Speaker Output. The ZONE VOLUME regulators are
not active.
Note! Distortion and sound quality worsening may occur when the knob in the maximum
position. It may damage the amplifier or speakers. This may void your warranty.
Note! High volume levels can damage this amplifier or speakers. This may void your
warranty.
TREBLE Regulator:
You can adjust treble output of the amplifier.
The default: the knob is in the center position : the marker on the knob in the vertical
position (0). Turn the knob counterclockwise (-) to decrease the amount of high
frequencies. Turn the knob clockwise to increase the amount of high frequencies (+)
The regulation will affect all speaker outputs and the Analog RCA Output (MONO OUT).
Note! Distortion and sound quality worsening may occur when the knob in the
maximum position. It may damage the amplifier or speakers. This may void your
warranty.
13
Advertisement
Table of Contents
