Brewing A Second Pot Of Coffee - Toastmaster TCM5W Use And Care Manual

simply remove carafe from warming plate. Dripping will automatically
cease. Return carafe to position on warming plate within a few seconds;
dripping will resume.
8. Upon completion of the brew cycle, wait about one minute until the
brew dripping from the filter basket into the carafe has stopped.
Carafe lid should be kept in place to facilitate safe serving and help
keep coffee at proper serving temperature.
9. To keep coffee hot, return carafe to the warming plate after serving.
The warming plate will automatically cycle to maintain ideal serving
temperature as long as the coffeemaker is on.
10. Switch coffeemaker to off when carafe is empty or when unit not in
use. (Model TCM10DW with automatic shut-off will automatically shut
off after two hours from start of brew cycle when set in auto position.
See further details on page 6.)
11. To brew another carafe of coffee, turn unit off and wait 10 minutes to
allow heating element to cool. Important: If unit is not allowed to cool
before immediate repeated use, water placed in water chamber may
become overheated and a spray of steam could be released from
opening, creating a risk of burns.

BREWING A SECOND POT OF COFFEE

As mentioned above, it is recommended that the coffeemaker should be in
off position for 10 minutes between cycles, in order to allow unit to cool.
While unit is in off position, dispose of used coffee filter, and rinse carafe
and filter basket in water. Place a fresh filter in basket. Repeat brewing
procedure.
SPECIAL INSTRUCTIONS FOR MODEL TCM10DW WITH ELECTRONIC
TIMER AND AUTO-OFF
Setting the clock
1. Plug the power cord into a wall outlet. The display will flash until the
time of day is set. NOTE: A power failure will also cause the display
to flash and it will be necessary to reset the clock.
2. To set the clock, hold the "Hour" button in for 3 or 4 seconds until the
hour setting begins to change. Push the "Hour" button until the correct
hour is displayed, noting that PM is indicated on the left of the display.
3. Push the "Min." button until the correct minutes are displayed. A few
seconds after you release the button the colon between the hour and
the minutes will begin to flash, indicating that the clock is running.
Setting the timer
1. While holding the "Program" button down, push and hold the "Hour"
button until the hour display begins to change. The coffee cup icon on
the left of the display will flash to indicate you are programming the
timer. Continue to press the "Hour" button until the correct hour is
displayed for the brew time you would like to set, noting that PM is
indicated on the left of the display.
5