1. Connect one end of a SAS cable to the drive expansion port 1 on controller A
2. Connect one end of a SAS cable to the drive expansion port 1 on controller A
3. Connect one end of a SAS cable to the drive expansion port 1 on controller B
4. Connect one end of a SAS cable to the drive expansion port 2 on controller B
5. Wait until the status of the storage system is Optimal.
6. Add drives to the storage enclosure one at a time. Add drive only after the
Cabling multiple enclosures
The following illustration shows the supported cabling configuration to connect a
DCS3860 storage subsystem with Gen2 controllers to multiple storage enclosures
and between the storage enclosures with SAS drive channels.
36
IBM System Storage DCS Series with Gen2 controllers Hard Disk Drive and Storage Enclosure Installation and Migration
Guide
and the other end to the In ( ) SAS connector 1 on the ESM located in slot A of
the EXP3800/DCS3700 expansion enclosure.
and the other end to the In ( ) SAS connector 1 on the ESM located in slot A of
the EXP3800/DCS3700 expansion enclosure.
and the other end to the In ( ) SAS connector 2 on the ESM located in slot A.
and the other end to the In ( ) SAS connector 2 on the ESM located in slot B.
IBM DS Storage Manager recognizes the drive you added earlier. Wait at least
30 seconds for the IBM DS Storage Manager to recognize a newly added drive.