Table of Contents
Advertisement
8.3. Using as a Floor Monitor
Notes
• When installing the speaker system on slippery floor,
put a non-slip mat under the speaker.
• Do not kick or stand on the speaker system, as this
will damage the speaker.
8.4. Attaching the Supplied Rubber Feet
Attach the rubber feet in the case of speaker storage or
on-floor speaker installation.
Note
The rubber foot has a direction (back and forth).
Align the datum line on the rubber foot with the positioning
mark (
) on the speaker unit as shown at right.
8.5. Attaching a Handle
The speaker system comes with a handy carrying handle.
Attach the handle on the speaker's top surface.
9. EQUALIZING BY THE DIGITAL SIGNAL PROCESSOR
The speaker system is capable of providing high-efficiency and wide range reproduction without using an
equalizer, however more clear and dynamic sound quality can be reproduced by using our digital signal
processor and performing its settings as shown in the tables below.
[For the HS-1200BT and HS-1200WT]
Filter
Frequency (Hz) Gain (dB)
HPF (12 dB)
PEQ
PEQ
1600
PEQ
2300
PEQ
5000
PEQ
14000
50
520
-4.0
-2.0
-4.0
-2.0
+3.0
The figure shows the HS-1200 series.
Rubber foot
(accessory)
[For the HS-1500BT and HS-1500WT]
Q
Filter
1.432
HPF (12 dB)
1.414
PEQ
5.764
PEQ
5.764
PEQ
1.011
PEQ
1.204
PEQ
Datum line
Positioning mark
Screw M6 x 30 (accessory)
Screw M6 x 30
(accessory)
Handle fitting bracket
(accessory)
Handle
(accessory)
Frequency (Hz) Gain (dB)
50
530
-3.5
1300
-3.0
2500
-3.0
4500
-3.5
14000
+1.5
Q
1.274
2.145
2.871
2.871
1.011
0.718
7
Advertisement
Table of Contents
