Installation Of Remote Controller - Mitsubishi SCM80ZA Manual

Inverter multi-split system room air-conditioner [4 room] (air to air pump type)
Table of Contents

Advertisement

4) Installing the main unit
a) Attach the washers and nuts to the ceiling suspension bolts.
b) Attach the suspension tool to the above nuts, and tighten the nuts.
c) If it is not leveled, the float switch may malfunction or may not start.
5) Connecting the drain pipes
a) Insert the drain hose as far as possible through the lower section of the side of the unit, and secure it with clamps.
b) The drain pipes should be set in a downward slope (over 1/100), and it should not have any bumps or traps along its
route.
c) The indoor drain pipes must be insulated.
6) Securing the wireless receiver
Flat head
machine screw
a) With a (–) screwdriver, secure the installation frame to the grooves on either sides of the wireless receiver.
b) Refer to the installation Instructions for each separately sold part, regarding the installing location of the wireless
receiver.

3.5.2 Installation of remote controller

(1) Mounting method of battery
Uncover the remote control switch, and mount the batteries
(UM-4 × 2 pieces) in the body regularly.
(Fit the poles with the indication marks, , & . without fail)
(2) Fixing to pillar or wall
(a) Conventionally, operate the remote control switch by hold-
ing in your hand.
(b) In the case of stationary operation service as by mounting
on the holder for the remote control switch, make sure that
the locating place is satisfactory for access service before
installing it.
(c) Avoid installing it on a clay wall etc.
M8 suspension bolt
Main frame
Tapping screw
Opposite
Drain hose
Clamp
M8 nut
M8 large washer (standard accessory)
M8 large washer (standard accessory)
M8 spring lock washer
M8 nut
Bumps
Note (1) Conduct the installation correctly, and ensure
that the water is draining correctly. It may lead
to water leaks.
Traps
Wireless receiver
Installation frame
Battery
Cover
Wood screw
ø3.5 × 16
Holder (remote control switch)
Adjust the installation to vertical attitude.
: http://splitoff.ru/tehn-doc.html
Avoid projecting the screw head.
91

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Skm25zaSkm22zaSkm40zaSkm50zaSrrm40zaSkm28za ... Show all

Table of Contents