Installation - Samsung SINGLE AC MNMSEH/EU Series Technical Data Book

14. Installation

Indoor Unit
Step 1 Checking and preparing accessories
The following accessories are supplied with the indoor
unit. The type and quantity may differ, depending on the
specifications.
User manual (1)
Clamp hose (1)
Step 2 Choosing the installation location
General requirements for installation location
Do not install the air conditioner in a location where it will
come into contact with the following elements:
• Combustible gases
• Saline air
• Machine oil
• Sulphide gas
• Special environmental conditions
Avoid installing the air conditioner in a location with the
following conditions:
• In areas where it is exposed to direct sunlight. Close to
heat sources.
• In damp areas or locations where it could come into
contact with water. (for example rooms used for laundry)
• In areas where curtains and furniture could affect the
supply and discharge of air.
• Without leaving the required minimum space around the
unit. (as shown in the drawing)
• In scarcely ventilated areas.
• On surfaces that are unable to support the weight of the
unit without deforming, breaking or causing vibrations
during the use of the air conditioner.
• In a position that does not enable the condensate
drainage pipe to be correctly installed. (at the end of the
installation. It is always essential to check the efficiency of
the drainage system)
Installation manual (1)
Flexible hose (1)
Insulation drain (1)
Cable-tie (8)
Rubber (8)
Space requirements for installation
Construction Standard for Inspection Hole
1 In case, the ceiling is tex tile, Inspection hole dose not
need.
2 In case, the ceiling is plaster board, Inspection hole
depends on Inside height of the ceiing.
a Height is more than 0.5m : Only "B" [Inspection for
PBA] is applied.
b Height is less than 0.5m : Both "A"&"B" are applied.
c "A"&"B" are inspection holes .
Unit Width(W)
"A"=W+100mm
Thermal insulation
sponge A (1)
Thermal insulation
sponge B (1)
Thermal insulation
sponge C (1)
"B"=500mm
20mm or more
20mm or more
41