Panasonic AK-HRP1005G Operating Instructions Manual page 108

Item
FORMAT Selects the format that is output from the CCU.
The CCU specifies the format to the camera based on the format selected here.
RETURN1 SELECT Sets the input allocations of return signal 1.
RETURN2 SELECT Sets the input allocations of return signal 2.
RETURN3 SELECT Sets the input allocations of return signal 3.
RETURN4 SELECT Sets the input allocations of return signal 4.
RETURN FS Set the delay mode for the HD return signals.
CAMERA NUMBER Changes the camera number controlled by the CCU.
D/C MODE Selects the down-conversion system for video output from SD SDI and VBS.
U/C MODE Selects the video up-conversion system used for SD SDI and VBS return videos.
BARS HD Specifies the HD color bar output by the CCU.
BARS SD Specifies the SD color bar output by the CCU.
C/B SETUP Set the SD signal output for use with color bar output.
The "SETUP7.5%" setting is not valid when "SD_SDI" is selected.
SDI8 OUT Performs PM/NORMAL switching for SDI8 OUT.
HD H COARSE Make the coarse setting of the H_FINE phase used with GL HD REF.
HD H FINE Make the fine setting of the H_FINE phase used with GL HD REF.
SD H COARSE Make the coarse setting of the H_FINE phase used with GL SD REF.
SD H FINE Make the fine setting of the H_FINE phase used with GL SD REF.
SD-HD V Set the vertical phase used with down-convert SD REF.
When the [24PsF GL MODE] setting for the CCU is "NORMAL", this is fixed to "0H".
When the [24PsF GL MODE] setting for the CCU is "ADVANCE", this is fixed to "0H_SD_DLAY".
With 1080/59.94i(24P), this is fixed to "0H".
SCH Adjust the SCH phase of VBS output.
CABLE CONNECT Displays the camera connection cable setting. You can change the setting via menu operations on the CCU
itself.
HYBRID
Indicates that the camera is connected via an optical fiber multi cable.
FIBER
Indicates that the camera is connected via an optical fiber cable.
FORMAT MODE(push) Selects the CCU format mode.
Setting details
- 108 -
ROP menu