Thermax CP3 Owner's/Operator's Manual

Professional hot water extraction cleaning system
Hide thumbs Also See for CP3:

Advertisement

CP3
Professional Hot Water extraction cleaning system
oWner/
oPerator
manual
Products for a Healthier Indoor Environment
thermaxaf.com
1-888-764-3700

Advertisement

Table of Contents
loading

Summary of Contents for Thermax CP3

  • Page 1 Professional Hot Water extraction cleaning system oWner/ oPerator manual Products for a Healthier Indoor Environment thermaxaf.com 1-888-764-3700...
  • Page 2: Table Of Contents

    CP3 Specifications ... 11 CP3 Wiring Diagram ... 11 Troubleshooting ... 12 CP3 Base Unit Schematic ... 13 CP3 Base Unit Parts List ... 14 Floor Wand Schematic ... 15 Floor Wand Parts List ... 16 Upholstery Wand Schematic ... 17 Upholstery Wand Parts List ...
  • Page 3: Message From The Corporate Office

    In an industry full of competition and choices, we at Thermax are grateful for your wise choice of the Thermax CP3, and we look forward to a lasting relationship as we service all your business needs.
  • Page 4: Identifying Features

    idenTifying feaTures 1) Clean Solution Tank 2) Stationary Lid with Solution Tank Fill Hole 3) Recovery Waste Tank 4) Recovery Tank Dome and Vacuum Seal 5) Power Cord 6) Brass Female Quick Connect Coupling for the Solution Hose 7) Auxiliary Female Outlet for the Optional Power Brush 8) Vacuum Inlet/Vacuum Hose Connector 9) Pump/Heater Switch...
  • Page 5: Inspection Upon Delivery

    Carefully unpack and inspect the Thermax CP3 and be sure all components ordered are included. Orders might be packed in more than one box. NOTE: Contact the carrier immediately regarding any damage incurred during shipping as it is your responsibility to file a damage claim with the carrier.
  • Page 6: Set-Up Procedure

    seT-up proCedure 1) Pre-mix cleaning solution as required for specific application in a five gallon (19 liter) pail. Pour pre-mixed solution through solution fill hole of system (page 3, #2). NOTE: This system has a built-in solution heat maintenance feature, start with hot water if possible. Hot water is hygienic and maximizes cleaning potential.
  • Page 7: System Clean-Up

    NOTE: To prevent shock hazard, remember to unplug main power source before inspection or repair of the system. aNNUally We recommend that your system be inspected once a year by an authorized Thermax service technician. For the location of your nearest Service Center, call 1-888-764-3700 or go to thermaxaf.com.
  • Page 8: Optional Package And Accessories

    & aCCessories The following optional packages and accessories do not come standard with your CP3. Contact your local distributor or the Corporate Office to receive details on how to purchase these items. ClEar VIEw Hand wand Part # 35-255-004 10’...
  • Page 9 Part # F-Hs-1uMr sInglE unIt rEntal raCk, MEtal Part # 32-502-01 Easy-Pull HandlE w/HardwarE PVC HandlE w/HardwarE, Part # CP3-Han-assy 1) PVC HandlE, Part # CP3-Han 2) HardwarE, Part # CP3-Han-Hdw douBlE unIt HEadEr sIgn Part # F-Hs-2uMr douBlE unIt rEntal...
  • Page 10: Rental Center Benefits

    Being recognized by the corporate website as an Authorized Thermax Rental Center will allow you the opportunity to receive referred national retail accounts in your distributing area.
  • Page 11: Cleaning Solutions

    Nearly thirty-five years of extensive field use and refinement have proven our safe and effective cleaning solution formulas. Thermax has a product for just about every carpet cleaning application. Formulated specifically to be used in conjunction with Thermax AF2 carpet cleaning systems the products and their application are further defined below.
  • Page 12: Cp3 Specifications

    • Weight ... . 39 lbs. ElEcTrical: • 115 Volt AC • 11.5 AMP • 50/60 HZ • CE TherMax Cp3 Wiring diagraM rEcOvEry TaNk: • Hygienic Stainless Steel • 3 U.S. Gallons vacUUM MOTOr: • 2-Stage By-Pass •...
  • Page 13: Troubleshooting

    TroubleshooTing CondiTion System Will Not Operate Vacuum Motor Will Not Run Pump Will Not Run Pump Runs But Will Not Spray/Weak Spray Loss of Vacuum Suction Cause 1) Plugged into dead outlet 2) Blown fuse or breaker 3) Defective power cord 4) Defective switch 5) Loose wiring 6) Improper connection...
  • Page 14: Cp3 Base Unit Schematic

    TherMax Cp3 sCheMaTiC...
  • Page 15: Cp3 Base Unit Parts List

    KIT, PILOT LIGHT, 120V, 16” CP3/CP5 04-054-00 SCREW, #8 X .5”, PH, PHIL, HILO, ZINC 03-455-02 DISCONNECT .375’ BARB 06-510-01 PLATE, FACE 2SW, 120 V, BLUE, CP3-2 04-371-00 CLAMP, WORM, .312” 05-210-01 GASKET, .125 THK X 6.75 OD, VAC MTR 04-144-00 BOLT, 1/4-20 X 1.25”...
  • Page 16: Floor Wand Schematic

    floor Wand sCheMaTiC...
  • Page 17: Floor Wand Parts List

    05-016-00 HOSE, .312” ID, VINYL BRAIDED - PRICE/FOOT 04-552-00 FITTING, .375 BARB .25 NPT, NYLON 29-561-000 ASSY, VALVE, WANDS, PLASTIC, CP3 03-459-00 FITTING, .25, 45 DEG, ELBOW 03-457-01 DISCONNECT, .25” MPT, CP3/PB309 for any other items, solutions, and spare parts or visit thermaxaf.com.
  • Page 18: Upholstery Wand Schematic

    upholsTery Wand sCheMaTiC...
  • Page 19: Upholstery Wand Parts List

    Wand parTs lisT iTEM NO. THErMaX NO. DEscriPTiON 04-457-06 MALE DISCONNECT 1/4 FTP 04-002-00 SCREW, 3/8 - 24 X 3/8 SOCKET SET 04-161-00 HOSE ASSEMBLY 29-561-0001 ASSY, VALVE, BRASS, W/HANDLE HW 03-466-01 HOSE BARB 3/16 X 1/8 MPT 35-273-000 ASSY, STEAM HEAD, 4” X 1.25” W/PLATE 04-359-00 CLAMP, HOSE, .437, SINGLE EAR...
  • Page 20: Power Brush Schematic

    poWer brush sCheMaTiC...
  • Page 21: Power Brush Parts List

    HOSE, .312” ID, VINYL BRAIDED - PRICE/FOOT 04-353-00 CLAMP, HOSE, .437, RED 04-552-00 FITTING, .375 BARB .25 NPT, NYLON 29-561-000 ASSY, VALVE, WANDS, PLASTIC, CP3 03-459-00 FITTING, .25, 45 DEG, ELBOW 03-457-01 DISCONNECT, .25” MPT, CP3/PB309 04-303-00 NUT, 10-32, HEX BRASS...
  • Page 22: Additional Commercial Units

    CP5 The Thermax CP5 is an industry proven performer, built to endure the most demanding carpet and upholstery extraction cleaning applications. Constructed in a portable footprint easily operated by one individual, the...
  • Page 23: Thermax Warranty

    Cp3 WarranTy The Thermax CP3 is warranted to be free from Manufacturers defect for a period of one (1) year on all non-electrical and electrical components. Warranty extended only to original owner. Proof of purchase required. Brass quick-disconnects, “O” rings, diaphragms, seals, grommets, gaskets, or any rubber or synthetic rubber or rubber-like parts are considered expendable in normal use and service, therefore are not included in this warranty.
  • Page 24 ____________________________________________________________________________________________ Name of Distributor ____________________________________________________________________________________________ Distributor Phone Number ____________________________________________________________________________________________ Date of Purchase ____________________________________________________________________________________________ Serial Number PLEASE NOTE: Retain this owner’s manual along with your copy of the Warranty Registration Form. Proof of purchase must accompany all warranty claims. World Headquarters 3315 East Texas St.

Table of Contents