Operation Tips - DeWalt 383609-01 Instruction Manual

DW900,DW901/383609 bc 5/8/02 2:59 PM Page 6
viewed from the rear of the tool).
7) While holding the tool with the open end
up, allow the motor to drop into the tool.
8) Insert the 1/4" hex wrench into the
spindle, and turn the spindle until the
gear teeth on the motor engage with the
gears in the tool. The motor will drop
about 1/4" into the tool housing (Figure
8).
9) Inspect all leads for damage; repair or
replace as required.
10) Reattach motor leadwires, routing wires
around the motor can. The wires should
be routed down and inward near the
LED. Ensure the wires are not blocking
the LED.
11) Replace the endcap, tighten the four fasteners to 0.9 N-m head
torque.

Operation Tips

• Pulling the trigger once uses about the same amount of battery
power as driving one fastener. Avoid running the tool at "no-load"
to conserve battery power.
• Avoid "feathering" the trigger. Allow the tool to stop automatically
when driving a fastener.
Accessories
Recommended accessories for use with your tool are available at
extra cost from your distributor or local service center.
CAUTION: The use of any non-recommended accessory may
be hazardous.
BATTERY PACKS
FIG. 8 DW9072 12.0V 4/5 Cell, Standard Capacity
DW9074 12.0V 4/5 Cell, Standard Capacity with State of
Charge Indicator
DW9070 12.0V High Capacity XR™ Pack
CHARGERS
DW9106 1 Hour Charger
DW9115 15-Minute Charger
DW9107 XR2 Charger
Important
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Full Warranty
D WALT heavy duty industrial tools are warranted for one year from
E
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. For warranty repair information,
call 1-800-4-D WALT. This warranty does not apply to accessories or
E
damage caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you may
have other rights which vary in certain states or provinces.
In addition to the warranty, D
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your
D WALT heavy duty industrial tool, simply return it to the participating
E
seller within 30 days for a full refund. Please return the complete unit,
transportation prepaid. Proof of purchase may be required.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-4-DEWALT for a free
replacement.
6
WALT tools are covered by our:
E