ADC NG3 User Manual page 23

ADCP-90-297 • Issue 7 • July 2006
GROMMET
(IF NEEDED)
PLATE
7. Route the cable fibers within the drawer as shown in
Figure 17
8. Locate the assigned adapter and lift up the adapter pack. (refer to
9. Remove the dust caps from the connectors and the rear side of the adapters and then insert
each connector into the appropriate adapter.
Note: Clean and inspect the connectors and adapters before mating them. For guidelines,
refer to
Danger: Infrared radiation is invisible and can seriously damage the retina of the eye. Do not
look into the ends of any optical fiber connector or adapter. Exposure to invisible laser
radiation may result. An optical power meter should be used to verify active fibers. A protective
cap or hood MUST be immediately placed over any radiating adapter or optical fiber connector
to avoid the potential of dangerous amounts of radiation exposure. This practice also prevents
dirt particles from entering the adapter or connector.
Page 16
© 2006, ADC Telecommunications, Inc.
MOUNTING
HOLES
YOKES
HEX
MOUNTING
SCREWS
Figure 15. Clamping Cable to Standard Termination Panel
(ribbon cable).
Subsection 5.3.
18431-B
Figure 16 (stranded cable) or
Subsection 5.1).