Texas Instruments solar TI-36X User Manual page 37

To set up the problem and perform the analysis:
1. Press . Select the desired type of analysis
from the menu and press
indicator displays.
2. Press .
3. Enter a value for X and press
1
4. Then:
• In 1-VAR stat mode, enter the frequency of
occurrence (FRQ) of the data point and press
. FRQ default=1. If FRQ=0, the data point is
ignored. Or,
• In LIN, LN, EXP, OR PWR, enter the value of Y
and press .
5. Repeat steps 3 and 4 until all data points are
entered. You can change or delete data points by
scrolling to the desired point and editing or pressing
. If you are in 2-VAR mode, you must delete
both the data point and the frequency. You can add
new points by scrolling to the last point and pressing
; the calculator will prompt you for the new data.
If you add or delete data points, the TI-36X
automatically reorders the list.
6. When all points and frequencies are entered:
• Press
to display the menu of variables
(see table for definitions) and their current
values. Or,
• Press
to return to the blank STAT screen.
You can perform calculations with data variables ( ,
, etc.). After such calculations, you can return to
the display of variables by pressing
You can return to the data entries again by pressing
.
35
Ti36eng1.doc TI-36X II Manual Linda Bower Revised:
01/10/03 10:47 AM Printed: 01/10/03 10:47 AM Page 35 of
48
. The STAT
.
again.