HELIX C ONE Manual page 26

Example configurations for TwinPower Link operation
Switch setting:
Master
Important: Both amplifiers must be set to the same impedance (see page 21, item 20; Impedance selection
switch). The filter settings (HPF, LPF, bass boost etc.) are assumed by the master amplifier. All controls of
the slave amplifier are deactivated.
* Optional accessory. The remote control is not part of the C ONEs standard equipment.
Master
Master
Attention: The second voice coil of the
subwoofer must be connected in re-
versed polarity to the amplifier which
is adjusted as "Slave"!
26
Amplifier connection in TwinPower Link operation
Master
*
RCA/Cinch signal
from the radio
RCA/Cinch cable
Speaker connection in TwinPower Link operation
Slave
Slave
Switch setting:
Slave
One subwoofer with one voice coil
(single voice coil)
Maximum output power of this configuration:
1 x 4 Ohms: 1,660 / 3,320 Watts
1 x 2 Ohms: 2,200 / 4,400 Watts
Note: The negative terminals of both amplifiers have to
be connected by using a speaker wire. The size should
be similar to the speaker wires which are used for the
subwoofer connection.
One subwoofer with dual voice coil
(dual voice coil)
Maximum output power of this configuration:
2 x 4 Ohms: 1,050 / 2,100 Watts
2 x 2 Ohms: 1,660 / 3,320 Watts
2 x 1 Ohms: 2,200 / 4,400 Watts
Note: In this configuration example an 1 Ohm configu-
ration in TwinPower Link operation is possible but not
advisable!
Slave