Disconnecting Hoses; Installation; Lubrication And Oil; Compatibility - North Star NSLA1683066 Owner's Manual

Disconnecting Hoses

1. Ensure regulated pressure gauge reads 0 PSI.
2. Remove hose from air outlet.

Lubrication and Oil

The air compressor pump was filled WITH oil at the manufacturer. Check air compressor pump oil level
before operating unit. See the Compressor Pump Oil section under Pump Oil.

Compatibility

Air tools and accessories that are run off the compressor must be compatible with petroleum-based
products. If you suspect that a material is not compatible with petroleum products, an air line filter for
removal of moisture and oil vapor in compressed air is required.
NOTE: Always use an air line filter to remove moisture and oil vapor when spraying paint.

Location

•
Locate the air compressor in a clean, dry, and well-ventilated area.
• Locate the air compressor at least 12" (30.5 cm) away from the wall or other obstructions that will
interfere with the flow of air.
•
Locate the air compressor as close to the main power supply as possible to avoid using long lengths of
electrical wiring. NOTE: Long lengths of electrical wiring could cause power loss to the motor.
•
THE AIR FILTERS MUST BE KEPT CLEAR OF OBSTRUCTIONS WHICH COULD REDUCE AIR
FLOW TO THE AIR COMPRESSOR.

Humid Areas

In frequently humid areas, moisture may form in the pump and produce sludge in the oil, causing running
parts to wear out prematurely. Excessive moisture is especially likely to occur if the unit is located in an
unheated area that is subject to large temperature changes. Two signs of excessive humidity are external
condensation on the pump when it cools down and a milky appearance in compressor oil. You may be able
to prevent moisture from forming in the pump by increasing ventilation or operating for longer intervals.
•
Improper electrical installation of this product may void its warranty and your fire insurance. Have
circuit wiring performed by qualified personnel such as a licensed electrician who is familiar with the
current national electrical code and any prevailing local electrical codes.
•
Risk of electrical shock. Improper electrical grounding can result in electrical shock. The wiring should
be done by a qualified electrician.
•
Risk of electrical shock. Electrical wiring must be located away from hot surfaces such as manifold
assembly, compressor outlet tubes, heads or cylinders.

Installation

Wiring

⚠WARNING
Page 13 of 36