Staple Selection - Hitachi N 14DSL Handling Instructions Manual

Cordless stapler
Table of Contents

Advertisement

Available languages
  • EN

Available languages

English
WARNING
In order to prevent any battery leakage, heat generation,
smoke emission, explosion and ignition beforehand,
please be sure to heed the following precautions.
1.
Make sure that swarf and dust do not collect on
the battery.
During work make sure that swarf and dust do not
fall on the battery.
Make sure that any swarf and dust falling on the
power tool during work do not collect on the battery.
Do not store an unused battery in a location exposed
to swarf and dust.
Before storing a battery, remove any swarf and
dust that may adhere to it and do not store it together
with metal parts (screws, nails, etc.).
2.
Do not pierce battery with a sharp object such
as a nail, strike with a hammer, step on, throw
or subject the battery to severe physical shock.
3.
Do not use an apparently damaged or deformed
battery.
4.
Do not use the battery in reverse polarity.
5.
Do not connect directly to an electrical outlets or
car cigarette lighter sockets.
6.
Do not use the battery for a purpose other than
those specified.
7.
If the battery charging fails to complete even
when a specified recharging time has elapsed,
immediately stop further recharging.
8.
Do not put or subject the battery to high
temperatures or high pressure such as into a
microwave oven, dryer, or high pressure container.
9.
Keep away from fire immediately when leakage
or foul odor are detected.
SPECIFICATIONS
POWER TOOL
Model
Voltage
Applicable staples
Amount of loadable staples
Rechargeable battery
Weight*
* Weight according to EPTA-Procedure 01/2003
CHARGER
Model
Charging voltage
Weight

STAPLE SELECTION

The staples indicated in the chart below can be used with
this stapler.
150 staples are bonded together to form a strip.
Contact the dealer from which you purchased the stapler
for details on obtaining the staples.
47
N14DSL
14.4 V
BSL1420: Li-ion
14.4 V (2.0 Ah 8 cells) 14.4 V (4.0 Ah 8 cells) 18 V (2.0 Ah 10 cells) 18 V (4.0 Ah 10 cells)
1.4 kg
UC18YRSL
14.4 V – 18 V
0.6 kg
10. Do not use in a location where strong static
electricity generates.
11. If there is battery leakage, foul odor, heat
generated, discolored or deformed, or in any way
appears abnormal during use, recharging or
storage, immediately remove it from the equipment
or battery charger, and stop use.
CAUTION
1.
If liquid leaking from the battery gets into your
eyes, do not rub your eyes and wash them well
with fresh clean water such as tap water and
contact a doctor immediately.
If left untreated, the liquid may cause eye-problems.
2.
If liquid leaks onto your skin or clothes, wash well
with clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3.
If you find rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using
the battery for the first time, do not use and return
it to your supplier or vendor.
WARNING
If an electrically conductive foreign object enters the
terminals of the lithium ion battery, a short-circuit may
occur resulting in the risk of fire. Please observe the
following matters when storing the battery.
Do not place electrically conductive cuttings, nails,
steel wire, copper wire or other wire in the storage
case.
Either install the battery in the power tool or
store by securely pressing into the battery cover
until the ventilation holes are concealed to prevent
short-circuits (See Fig. 1).
Ref. Fig.
150 staples
BSL1440: Li-ion
BSL1820: Li-ion
1.7 kg
NOTE
Only staples manufactured by Hitachi may be used.
Staples other than those manufactured by Hitachi
may cause jamming and subsequent malfunctions.
Shape
N18DSL
18 V
BSL1840: Li-ion
1.5 kg
1.8 kg
(Size unit: mm)
Staple
A
B
C
BF1206
BF1210 11.75
0.5
0.7
BF1213
D
6
10
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

N 18dsl

Table of Contents