Ss1002/2002 Supplemental Information; Installing The Box To The Faceplate; General Instructions - Audiocom SS-1002 Technical Manual

Installing the Box to the Faceplate

General Instructions

If you ordered SS1002/2002 boxes and faceplates separately, use these instructions to assemble the speaker stations. Once you
have assembled the stations, refer to the User Manual for all installation and operation information.
SS1002 wire connections for use in Audiocom System
TABLE 2.
XLR Connector on Box Terminal Strip on Circuit Board
Pin 1
Pin 2
Pin 3
SS1002 wire connections for use in Clear-com System
TABLE 3.
XLR Connector on Box
Pin 1
Pin 2
Pin 3

SS1002/2002 Supplemental Information

Step 1. Connecting the Wires from the Box to the Faceplate
Use the appropriate pin connections, see Table X, to connect the wires from the XLR audio
connector on the box to the terminal strip on the circuit board. (Or, in the case of the U box,
connect wires from the intercom system to the terminal strip.) To insert a wire into the
terminal strip, push back the green lever on the top of the terminal, as shown, then insert
the wire and release the lever.
TB1-1
TB1-3
TB1-4
Terminal Strip on Circuit Board
TB1-1
TB1-3
TB1-4
Description
DC Common
Audiocom Channel audio low and +24VDC phantom
power
Audiocom Channel audio high and +24VDC phantom
power
Description
Common
Clear-com power input
Clear-com audio / call signal
APPENDIX A
21