Channel Select (Ss-2002 & Ss-2002Rm Only); Headset/Headphone/Speaker/Microphone Selection; Receiving Calls - Audiocom SS-1002 Technical Manual

Single-channel intercom speaker station two-channel intercom speaker station two-channel rack mount intercom speaker station
Hide thumbs Also See for SS-1002:
Table of Contents

Advertisement

To adjust sidetone on SS-2002 and SS-2002RM headphones, do the following:
Activate channel 1.
1.
Activate talk and listen.
2.
Set the volume control to the normal listening level for intercom audio.
3.
While talking into the microphone, use a small, flat-head screwdriver to adjust the channel 1 sidetone trimmer so
4.
you can hear your own voice in the headphones at an acceptable level.
Activate channel 2.
5.
Repeat the steps 1 - 5 to adjust the channel 2 sidetone.
6.
Channel Select (SS-2002 & SS-2002RM Only)
To select a channel on the SS-2002 and SS2002RM, do the following:
>
Tap the Ch Select key to select channel 1 or 2.
The key is green when channel 1 is selected and red when channel 2 is selected.

Headset/Headphone/Speaker/Microphone Selection

To use a headset or telephone style handset:
set the Speaker and Panel Mic keys to off.
To use headphones with the built-in panel microphone:
set the speaker key to off.
set the panel mic key to on.
make sure a gooseneck microphone is not inserted in the panel microphone connector.
To use headphones with a gooseneck microphone,
set the speaker key to off.
set the panel mic key to on.
make sure a gooseneck microphone is inserted in the panel microphone connector.
To use the speaker with a handheld dynamic microphone:
set the speaker key to on.
set he panel mic key to off.
To use the speaker with the built-in panel microphone:
set the speaker and panel mic keys to on.
make sure a gooseneck microphone is not inserted in the panel microphone connector.
To use the speaker with a gooseneck microphone:
set the speaker and panel mic keys to on.
make sure a gooseneck microphone is inserted in the panel microphone connector.

Receiving Calls

When there is an incoming call signal, the call key flashes red. There is a beep tone in the headphones or speaker if the beep
feature is activated.
NOTE:
The incoming call indication is provided only for the currently selected intercom channel in the case of SS-2002
& SS-2002RM models.
To receive calls, do the following:
16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ss-2002Ss-2002 rm

Table of Contents