Napa 791-5230 Operating Manual & Parts List

BEFORE USING THIS DEVICE, READ THIS
MANUAL COMPLETELY AND THOROUGHLY,
UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND
MAINTENANCE REQUIREMENTS.
It is the responsibility of the device owner to make sure all personnel
read this manual prior to using the device. It is also the responsibility
of the device owner to keep this manual intact and in a convenient
location for all to see and read. If the manual or product labels are lost
or not legible, contact NAPA for replacements. If the operator is not
fluent in English, the product and safety instructions shall be read to
and discussed with the operator in the operator's native language by
the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
SPECIFICATIONS
Capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Ton
Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-1/2"
Saddle Size . . . . . . . . . . . . . . . . . . . . . . .2-3/4" x 3-1/2"
Lift Range . . . . . . . . . . . . . . . . . . . . . . . . 9-1/2" - 15-3/4"
Base . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-7/8" x 7-7/8"
Shipping Weight . . . . . . . . . . . . . . . . . . . . . . . . . . 38 lbs .
791-5230
FORK LIFT STANDS (PAIR)
WARNING
Read, study, understand and follow all instructions before
operating this device • Inspect the jack stands before each use.
Do not use if damaged, altered, modified, in poor condition,
or unstable due to loose or missing components. Make
corrections before using • User and bystanders must wear
eye protection that meets ANSI Z87.1 and OSHA standards
• Use as a matched pair only • Use only on a hard level surface
capable of supporting the load • Stands are to be used in
matched pairs to support one end of a vehicle only. Do not
simultaneously support both ends or one side of a vehicle
• Center load on saddle. Do not use saddle lugs to support
the load • Do not use jack stands beyond its rated capacity.
Do not shock load • Maximum load capacity per matched pair
shall not exceed the rated capacity of the individual stand
• Apply the emergency brake, put the gear shift lever in park
or in gear if a manual shift transmission, and chock the tires
that will not be lifted off the ground • Check the stands for solid
contact with the ground and vehicle • Make sure the stand's
locking pins are fully engaging the stand on both sides and the
support column saddle is making contact with a vehicle support
surface that can support the load • Ensure both stands are
set at same height and locking pins are fully engaged • Do
not crawl under vehicle when placing/removing stands
• Consult the vehicle manufacturer for the proper frame support
locations • No alterations shall be made to these stands
• Never use the stand's lower support plate (if so equipped)
as a load bearing surface for the locking pin • Failure to heed
these warnings may result in serious or fatal personal injury
and/or property damage.
WARNING: This product can expose you to chemicals
including nickel, which is known to the State of California
to cause cancer and birth defects or other reproductive
harm. For more information go to www.P65Warnings.
ca.gov.
1
MODEL # 791-5230
5 TON CAPACITY
ASME PASE-2014
rev. 03/20/18