Delta MultiChoice T17T053 Owner's Manual page 4

Valve trim

Hide thumbs Also See for MultiChoice T17T053:

Available languages

Installation

Showerhead and Tub Spout Installation

FOR TUB SPOUT INSTALLATION:

Refer to the installation instructions supplied with your spout. Do not connect deck mount spouts to in-wall

valves. Do not use hand showers connected in lieu of a tub spout to a tub/shower valve. Do not use PEX

tubing for tub spout drop.

B-1

B-2

68883 Rev. J

FOR SHOWERHEAD INSTALLATION:

Apply plumber tape to pipe threads on both ends

of the shower arm (1). To prevent damage to finish

on shower arm, insert wall end of shower arm into

shower flange (2) before screwing arm into riser

connection.

Thread showerhead (3) onto shower arm. Do not

overtighten showerhead.

Slip-On Installation

The copper tube (1) must be 1/2" nominal copper.

Important: If it is necessary to cut the copper tube,

the end must be chamfered free of burrs to prevent

cutting or nicking O-ring inside the spout. Slide

spout over copper tube flush with the finished tub

or wall surface. Tighten set screw (2), but do not

overtighten.

Iron Pipe Installation

Install threaded pipe nipple (1) to extend past

finished wall. Apply plumber tape to threads on

pipe nipple and screw on tub spout.

Table of Contents