Ii-3-1-2 Details Page For Lan1 - Ipv6 Setup - Draytek Vigor3910 Series User Manual

router (the most common case), or a separate server, that hands out IP addresses to DHCP
clients.
Alternatively, static IP addresses can be manually configured on LAN clients as part of their
network settings. No matter how IP addresses are configured, it is important that no two
devices get the same IP address. If both DHCP and static assignment are used on a network, it
is important to exclude the static IP addresses from the DHCP IP pool. For example, if your
LAN uses the 192.168.1.x subnet and you have 20 DHCP clients and 20 static IP clients, you
could configure 192.168.1.10 as the Start IP Address, 50 as the IP Pool Counts (enough for the
current number of DHCP clients, plus room for future expansion), and use addresses greater
than 192.168.1.100 for static assignment.
I I - 3 - 1 - 2 D
I I - 3 - 1 - 2 D
There are two configuration pages for LAN1, Ethernet TCP/IP and DHCP Setup (based on IPv4)
and IPv6 Setup. Click the tab for each type and refer to the following explanations for
detailed information. Below shows the settings page for IPv6.
66
e t a i l s P a g e f o r L A N
e t a i l s P a g e f o r L A N
1 I P v 6 S e t u p
1 I P v 6 S e t u p
–
–
Vigor3910 Series User's Guide