Phaser 480X Rear Panel Switches - Tektronix Phaser 480X User Manual

7
Front and Rear Panels

Phaser 480X rear panel switches

7-2
Phaser 480X Color Printer
Rear panel switches
Switch Function
1 Reset/run
2, 3, and 4 Diagnostics
5 Start Job
6 Cleaning mode
7 Baud Rate
8 and 9 Color correction See table "Switches 8 and 9: Color Correction Mode" on
Settings
Up : The printer resets and does not accept data while
the switch is in this position.
Down . The printer runs a self-test, then proceeds to run
normally. Leave the switch down for normal operation.
Up . When only Switch 4 is moved from down to up , the
printer prints a configuration page.
Down . Normal operation.
Up : The Sys/Start job on the hard disk does not run.
Down: The Sys/Start job runs if the file exists on the
disk.
Up: At power-up, the printer rotates the rollers for a few
seconds, then stops the rotation. See "Cleaning the
printer" on page 4-5.
Down: Normal operation.
Up : Fixed. Sets the serial communication parameters
to 1200 baud, software flagging, and ignore parity.
Down : Variable. Lets you change the serial
communication parameters. The factory setting is 9600
baud, software flagging, and ignore parity.
page 7-3.