Festool PRECISIO Series Original Operating Manual page 20

Use only original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/Service
5
3
2
1
The machine is equipped with special self-dis-
connecting carbon brushes. If they are worn, the
power is interrupted automatically and the ma-
chine comes to a standstill.
Maintain your machine regularly to make sure it
functions reliably:
- Use an extractor to remove the dust deposits.
- Keep the guide rods clean and grease regu-
larly.
- Keep the toothed gears behind the rotary han-
dle [2-3] clean.
- Replace worn or damaged table inserts [1-4].
- If wood chips block up the extraction channel
on the lower protective cover, unscrew the ro-
tary knob [5-8] and move the fl ap [5-6] approx.
8 mm to open up a gap so that the blockage is
removed.
- If the blockage is serious or the saw seizes
when the initial cut is made, unscrew the fas-
teners [5-7] using the hexagon wrench so that
the fl ap [5-6] can be opened completely. Close
the fl ap again prior to use.
- After completing work, wind up the power ca-
ble onto the holder [1-3].
- A damper allows the saw unit to retract evenly
along the entire cutting length. If this is not the
case, the damper can be adjusted through the
hole [3-5].
Filter cleaning (CS 70 EB only)
You should clean the air intake fi lter [3-2] if the
temperature monitor (see 7.1) triggers shutdown
cycles more frequently without the machine be-
ing overloaded excessively.
Unscrew the rotary knob [3-1].
Remove the fi lter insert.
Knock off the dust or use an extractor on the
surface of the fi lter.
Insert the fi lter again.
20

If damaged, replace the fi lter with a new fi l-
ter cartridge.
10 Disposal
Do not throw the power tool in your household
waste! Dispose of machines, accessories and
packaging at an environmentally-responsible
recycling centre. Observe the valid national reg-
ulations.
EU only: In accordance with European Directive
on waste electrical and electronic equipment
and implementation in national law, used elec-
tric power tools must be collected separately
and handed in for environmentally friendly recy-
cling.
Information on REACh: www.festool.com/reach.
11 EU Declaration of Conformity
Bench-mounted circular saw
and circular trimming saw
CS 70 E
CS 70 EB
Year of CE mark
We declare under sole responsibility that this
product complies with all the relevant require-
ments in the following Directives, standards and
normative documents:
2006/42/EC, 2004/108/EC,
61029-1, EN 61029-2-1, EN 55014-1, EN 55014-
2, EN 61000-3-2, EN 61000-3-3
Festool Group GmbH & Co. KG
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Martin Zimmer
Head of Research, Development and Technical
Documentation
2012-12-19
Serial no.
491304, 491305, 493474
491302, 491303, 493559
1995
2011/65/EU, EN