Dsp Sound Modes; Stereo Mode; Surround Mode - Technics SA-DX1050 Operating Instructions Manual

DSP SOUND MODE
A
DSP SOUND MODE
B
DSP SOUND MODE
C
DIGITAL INPUT
16
RQT5802
DIGITAL INPUT
SPEAKERS
A
SPEAKERS
A
DIGITAL

DSP sound modes

The digital sound processor (DSP) in this unit can decode Dolby
Digital and DTS digital signals. It automatically determines the type
of signal, PCM, Dolby Digital, or DTS, and processes it accordingly.
The DSP can add surround-like effects to stereo sources (analogue
or PCM signals).
Choose from the STEREO, SURROUND, or SFC modes.
The DSP may interfere with radio reception. You can turn it off if this
occurs ( \ page 22).
Output is in stereo when you turn the DSP off so sound is only
heard through the front speakers.
Note
¡PCM with a sampling frequency of 44.1 kHz is the digital signal
format normally found on CDs. Some DVDs also use this format
but often with a higher sampling rate.
¡This unit cannot process other digital signal formats, such as
PCM signals with sampling frequencies of 96 kHz and 192 kHz
and MPEG.

STEREO mode

A
L R
Use this mode to play digital or analogue stereo sources or to play
SOUND MODE
surround sources through two speakers. When surround sources
STEREO
are played in this mode, the sounds intended for the other speaker
channels are played through the front speakers.
B

SURROUND mode

Select this mode when you are playing a digital surround source
(Dolby Digital or DTS) or an analogue source that is recorded with
Dolby Surround (VCR, for example).
L C R
LS LFE RS
C
Changing the recognition mode
SOUND MODE
SURROUND
In rare cases, the unit may have trouble recognizing the digital
signals on discs. With the PCM signals on CDs, this may cause the
beginning of a track to be cut off. Engage the PCM FIX mode if this
occurs. With DTS, the signals may not be recognized at all.
Engage the DTS FIX mode if this occurs.
This mode does not need to be changed under normal
circumstances. Change it only if the unit appears to be having
trouble recognizing the software you are playing.
While the input source is selected and digital input is engaged:
FIXED Press and hold [DIGITAL INPUT].
PCM
The current mode is displayed. Press again to change the mode.
Each time you press the button:
AUTO / PCM FIX / DTS FIX
FIXED
When a FIX mode is on, the unit cannot process other signals. This
may cause noise to be output. Select "AUTO" if this occurs.
The selected mode is stored even if the unit is turned off.