Advertisement
MOUNTING LOCATION:
Right side of the radio JR
TOOLS REQUIRED:
(2) Hook tools, MB type
(recommended)
T-15 Torx Driver
HARDWARE INCLUDED:
None
STEP #1: Lift off the shift indicator with your hands, (Auto trans). Or remove the
shifter boot (Man. Trans) with your hands and invert the boot so it sits up and away
from the console. Remove the shifter bezel by lifting up from the front with your
hands and tilting it up and forward to release back tab.
STEP #2: With hook tool, remove the upper switch panel by inserting tool above
panel, and pull to release (4) TIGHT! Clips. Remove (4) radio screws. Pull out radio
to allow the removal of (1) lower right radio screw above the pin. Place InDash by
PanaVise Mount over pin and screw hole, and reinstall screw.
STEP #3: Replace all in reverse order.
INSTALLATION IS COMPLETE. ENJOY YOUR NEW INDASH by
There may be recent updates to this Instruction Sheet, please visit our web-site or contact
PanaVise Products, Inc. for the latest revision as well as for the most complete up-to-date
PanaVise InDash Applications List: 7540 Colbert Dr., Reno, NV, Phone: 800.759.7535,
03-17-09
775.850.2900, Fax: 800.395.8002, www.panavise.com © 2002 PanaVise Products, Inc.
C
P
ELL
HONE
I
NSTALLATION
PART#:
MFG:
MODELS & YEARS: CLK-Class 05-09
(CLK-Class Instructions)
PANAVISE MOUNT.
Final Install Picture
& M
M
EDIA
OUNT
I
NSTRUCTIONS
75128-905
MERCEDES-BENZ
I-75128-905
Page 3 of 3
* * ADVISEMENT * *
Read instructions completely prior to
starting installation. All InDash
Mounts are designed so that after
installation, phone is facing normal
driver position for left-hand drive
vehicles. This mount is not designed
to be used in foreign countries with
right-hand drive vehicles. Use extreme
care when working around the plastic
components on the dash. Excess force,
can cause breakage of the plastic
components.
Removal of Console Top
Removal of Switch Panel
Removal of Climate Control
InDash Mounting Location
Advertisement
