Advertisement
MOUNTING LOCATION:
Right side of the radio JR
TOOLS REQUIRED:
Hook tool
T-15 Torx Driver
HARDWARE INCLUDED:
None
STEP #1: Remove air vents. This is done by locating a (1) small set of lock clips on
the left side of each air vent. First, release the upper clips by inserting hook tool into
upper clips. Pry just enough to pivot the air vents up one at a time and allow access to
the Torx screws inside the air vent assembly. (2) Unscrew screws just enough to
release from dash, you do not need to remove screws completely. Release the lower
clips in the vents to turn the vents down by (3) inserting hook tool into lower clips, and
pry out slightly. With flashlight locate the (2) catch lugs at the upper corners of the
vent assembly. Use Torx driver to insert into catch lug and press down to release the
top of the air vent assembly. Remove air vent assembly by working it out carefully,
and set aside.
STEP #2: With T-20 Torx driver remove the (2) Torx screws above the switch panel above the
radio. Pull out the switch panel releasing (2) clips. Open ashtray door. The (2) T-20 Torx screws
to the lower right and left side of the climate control.. Remove these (2) screws that are angled
towards the center with a extended shaft T-20 Torx driver. Set climate control off to the side.
Remove the (4) T-20 Torx screws that hold the radio in place. Slide the radio out enough to get
at the T-20 torx screw to the right of the radio.
STEP #3: With the Torx driver remove the screw to the right side of the radio. This screw is
directly above a small plastic pin, and about 2-1/2" deep into the dash. Place the top hole of the
InDash by PanaVise Mount over the screw hole, and the bottom hole over the pin. Reinstall
the screw, and tighten.
STEP #4: Replace the bezel in reverse order. Replace the air vents by inserting the assembly
back in, and align the screws to the holes, push the top of the air vents in until they snap in.
Release lock on air vent pivot, and pivot air vents up to tighten the screws inside the air vent
assembly. Check operation of the center thumb wheel on the vent assembly for operation.
INSTALLATION IS COMPLETE. ENJOY YOUR NEW INDASH by
InDash Installed Showing Location
C
P
ELL
HONE
I
NSTALLATION
PART#:
MFG:
MODELS & YEARS: C-Class 05-07
(C-Class Instructions)
PANAVISE MOUNT.
& M
M
EDIA
OUNT
I
NSTRUCTIONS
75128-905
MERCEDES-BENZ
InDash Mounting Screw
I-75128-905
Page 2 of 3
* * ADVISEMENT * *
Read instructions completely prior to
starting installation. All InDash
Mounts are designed so that after
installation, phone is facing normal
driver position for left-hand drive
vehicles. This mount is not designed
to be used in foreign countries with
right-hand drive vehicles. Use extreme
care when working around the plastic
components on the dash. Excess force,
can cause breakage of the plastic
components.
(1) Lock Clips
Torx screwdriver insert
03-17-09
Advertisement
