MOUNT ADAPTER INSTALLATION
Install adapter plates as follows:
1. Position the adapter plate against the driver's side
portion of the mount adapter as shown. Insert a
3/4" x 2-3/4" cap screw through the lower front
adapter plate hole and through the appropriate
hole on the mount adapter. Secure with a locknut.
Mount Adapter
3/4" Locknut
3/4" x 2-3/4" Cap Screw
2. Insert a cap screw through the rear adapter plate
hole, through the slot on the mount adapter and
through a washer. Secure with a locknut.
3. Repeat for the passenger's side. Tighten all
fasteners according to the torque chart.
NOTE: After fi ve to ten hours of snowplow usage,
retorque all undercarriage assembly fasteners.
Lit. No. 69656, Rev. 03
MOUNT ADAPTER INSTALLATION
3/4" Washer
Adapter Plate
8
March 15, 2010